You can find the most up-to-date drivers for your system here, from Silicon Labs.ĭownload and unzip the drivers. Currently, drivers are available for the following systems: You will need to download the appropriate drivers for your system. If you are using a 5.x driver and need support you can download archived Application Note Software. Application Note Software downloads affected are AN144SW.zip, AN205SW.zip and AN223SW.zip. The CP210x Manufacturing DLL and Runtime DLL have been updated and must be used with v6.0 and later of the CP210x Windows VCP Driver. It is widely used to upload firmware to the Various development boards, but it can communicate with any serial-enabled deviceįor a quick tutorial on CP210X Virtual Com Port (VCP) driver installation procedures for various CP2102 based products from rhydoLABZ like USB To RS232 Converter- CP2102 & much more… The CP210x USB to UART Bridge Virtual COM Port (VCP) drivers are required for device operation as a Virtual COM Port to facilitate host communication with CP210x products The chip on the board translates the serial data coming from a device into USB data and vice-versa. The CP210X makes USB communication with a micro controller or serial device. Here we are discussing how to open a serial connection to an embedded device on Windows XP. Many embedded devices communicate over the serial port connection as most modern computers lack a hardware serial port USB adapters provide the serial interface.
